Operation Manual

Rascal 600B/700B Owner’s Manual

EMC Part: 19278100 Rev. 3 ◦ 06/29/2009

Self-Centering Stabilizer Magnets

The magnets should be occasionally cleaned of metal filings or other metal

debris with a soft cloth. While cleaning avoid metal “splinters” from

penetrating your skin.

ILLUSTRATION 18 – Stabilizer Magnets

Clock Battery

After time, the clock may begin to lose time, or stop, when the battery runs

down. The battery is easily replaced by removing the clock from the dash

and prying open the clock’s case, then inserting a new battery. Use the

following steps to replace the clock battery:

• Remove clock from the dash.

• Use a small screwdriver to open the case by inserting the screwdriver

blade into the notch on the back cover. Gently twist blade so that the

back cover comes off.

• Slide the metal battery cover plate aside and remove battery.

• Install new battery with positive pole (+) facing outwards. Slide battery

cover back in place over new battery. After replacing battery, make sure

time setting is correct before replacing clock into dash.

Battery Types: SR626SW, UCC 377, Ray-O-Vac RW329

Electrical Connections

Check battery terminals and all plug connectors to make sure that a tight

connection is made. If battery terminals are corroded, disconnect the leads

and clean all connections with a soft wire brush. Reconnect leads and

apply a protective coating (e.g., petroleum jelly, etc.) to prevent corrosion.