Operation Manual

POWER SEATING OWNERS MANUAL
60° and 70° (FIGURE 10)
1. Remove the footrest from the wheelchair. Refer to INSTALLING/REMOVING
SWINGAWAY FOOTREST in this procedure of the manual.
2. Remove the hex screw and coved spacer and slide the footrest up or down on its mounting tube
until the desired footrest height is achieved.
3. Reassemble the hex screw and coved spacer through the footrest upper support and mounting
tube as shown in FIGURE 10.
4. Securely tighten the hex screw and coved spacer.
5. Install the footrest assembly onto the wheelchair. Refer to INSTALLING/REMOVING
SWINGAWAY FOOTREST in this procedure of the manual.
6. Repeat STEPS 1-5 for the opposite side of the wheelchair, if necessary.
FIGURE 10 – ADJUSTING SWINGAWAY FOOTREST HEIGHT –
60° AND 70°
70° AND 90° FOOTRESTS (FIGURE 11)
Adjusting
1. Remove any accessories that are attached to the footrests.
2. Remove the 6mm socket bolt, coved washer and 6mm locknut that secure the footplate to the
footrest support.
3. Reposition the footplate to the desired height.
4. Reinstall the socket bolt through the mounting holes of the footplate and footrest support.
WARNING:
DO NOT over tighten socket bolt and locknut. Footrest MUST be able to rotate
upward from the horizontal to the vertical position. Secure the footplate to the footrest
support with the coved washer and locknut.
FIGURE 11 – INSTALLING/REMOVING/ADJUSTING THE FOOTREST
70° MFX AND 90° FOOTRESTS
EMC Part: 19254300 ● Rev. 03 ● 07/28/06
16