Operation Manual

POWER SEATING OWNERS MANUAL

INSTALLING/REMOVING SWINGAWAY FOOTREST

INSTALLING

1. Turn the footrest to the side (open footplate is perpendicular to the wheelchair).

2. Insert the footrest assembly mounting pin into the mounting tube of the wheelchair frame.

3. Rotate the footrest towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4. Repeat STEPS 1-3 for the other footrest assembly.

5. If necessary, adjust the footrest height. Refer to ADJUSTING SWINGAWAY

FOOTREST HEIGHT in this procedure of the manual.

FIGURE 9 – INSTALLING/REMOVING SWINGAWAY FOOTREST

REMOVING

1. Push the footrest release lever inward while rotating the footrest outward.

2. Lift the footrest assembly out of the mounting pin of the wheelchair frame.

3. Repeat STEPS 1-2 for opposite side, if necessary.

ADJUSTING SWINGAWAY FOOTREST HEIGHT

HEIGHT ADJUSTMENT RANGES:

• 60° 13-17-inches

• 70° 13-17-inches

• 90° 5-8-inches

• 90° 5-11-inches (with 3-inch extension)

NOTE: If using ANY type of extension with the ADJUSTABLE FLIP-UP FOOTPLATE,

refer to ADJUSTABLE ANGLE FLIP-UP FOOTPLATE ADJUSTMENT in this procedure

of the manual.

EMC Part: 19254300 ● Rev. 03 ● 07/28/06