Operation Manual

POWER SEATING OWNERS MANUAL

OPERATING THE POWER LEGREST

Specifications:

• Operating speed – 20.0mm/s

• Stops automatically at end of travel in both directions

Operating the Power Legrest:

The standard method for operation of the powered seating system is through a Toggle

Switch. Figure 8 below details operation using a toggle switch. Note: The powered

legrests of the seating system may in some cases be run through the joystick.

FIGURE 8 – Four Way Toggle Switch

Illuminating

LED light

• To extend left side legrest, move the toggle switch left.

• To retract left side legrest, release the toggle switch to neutral position, then move the

toggle switch left.

• To extend right side legrest, move the toggle switch right.

• To retract right side legrest, release the toggle switch to neutral position, then move

the toggle switch right.

NOTE: The four-way toggle switch will alternate functions (extending and

retracting the actuator) after it has been released to the neutral position for a

minimum of one (1) second

REMOVING THE POWER LEGREST

1. Disconnect power legrests from jumper cable.

2. Push powered legrest release handle towards the opposite side of the wheelchair and swing

legrest to the outside of the wheelchair.

3. Lift UP on powered legrest and remove from wheelchair.

4. Repeat STEPS 1-3 for opposite power legrest.

EMC Part: 19254300 ● Rev. 03 ● 07/28/06