Operation Manual

POWER SEATING OWNERS MANUAL

CALFPAD HEIGHT (FIGURE 6)

1. Turn the calfpad towards the outside of the wheelchair.

2. Slide calfpad up or down until desired position is obtained.

3. Turn the calfpad towards the inside of the wheelchair.

CALFPAD DEPTH (FIGURE 6)

1. Remove the hex bolt and locknut that secure the calfpad and spacer to the adjustment bracket.

2. Move the legrest to one (1) of three (3) positions.

3. Reinstall the hex bolt through the spacer and calfpad.

NOTE: Make sure hex bolt sits flush adjustment bracket channel.

4. Reinstall locknut onto the hex bolt and tighten securely.

FIGURE 6 – ADJUSTING LEGRESTS –

CALFPAD HEIGHT/DEPTH

LEGREST HEIGHT (FIGURE 7)

1. Remove the button screw that secures the adjustment link and two (2) washers to the legrest

support.

2. Move adjustment link to one (1) of three (3) positions.

3. Line up the two (2) washers and adjustment link with the mounting hole in the legrest support.

4. Install the button screw and tighten securely.

FIGURE 7 – ADJUSTING GENIUS LEGRESTS –

LEGREST HEIGHT/DEPTH

EMC Part: 19254300 ● Rev. 03 ● 07/28/06