Operation Manual

POWER SEATING OWNERS MANUAL

ADJUSTING POWER ELEVATING LEGRESTS

FOOTPLATE HEIGHT (FIGURE 5)

1. Note the angle of the footplate in relation to the legrest as shown in FIGURE 5.

2. Loosen, but do not remove the three (3) hex bolts and locknuts that secure the footplate to the

legrest.

3. Adjust the footplate to the desired height.

4. Line up the footplate to the angle noted in STEP 1.

5. While holding the footplate, tighten the three (3) hex bolts and locknuts securely.

FIGURE 5 – ADJUSTING LEGRESTS –

FOOTPLATE HEIGHT/ANGLE

FOOTPLATE ANGLE (FIGURE 5)

1. Remove the rear hex bolt and locknut that secure the footplate to the legrest.

2. Move the footplate to the desired angle.

3. Install the hex bolt through the mounting holes that correspond to the desired footplate angle.

4. Install the locknut onto the hex bolt.

5. While holding the footplate, tighten the hex bolt and locknut securely.

EMC Part: 19254300 ● Rev. 03 ● 07/28/06