Operation Manual

POWER SEATING OWNERS MANUAL
About Drive Lockout:
Drive lock-out is a feature designed to prevent the wheelchair from being driven while in any
recline/back angle combination over 20º
RELATIVE TO THE VERTICAL POSITION.
When the drive lock-out feature has been activated, the LED on the four-way toggle switch will
light (Figure 3). To deactivate the drive lockout feature simply return the chair to the lowered
position and the back to an upright position.
OPERATING THE ARMRESTS
Tilt and Recline Armrests (TRARM):
The TRARM serves the Tilt, Recline, and Combination Systems. See Figure 4.
The TRARM is available in Desk and Full Length.
The TRARM is designed to ‘track’ with the reclining back as it reclines and as it inclines.
The TRARM is height adjustable and is a Flip Back design.
The TRARM may also be equipped with an optional Clothing Guard.
FIGURE 4 – TRARM DOUBLE PIVOT
Release Latch at
base of support bar.
Seating at Reclined Position
Rear pivot
adjustment
ADJUSTABLE HEIGHT:
1. Set the rear pivot attachment to the desired height and tighten the socket bolt with
appropriate tool.
2. Set the adjustable support tube and tighten by removing hex screws, moving the bar to
the correct height, and re-inserting the screws.
LOCK / UNLOCK PROCESS:
1. To unlock TRARM press down on the release latch at the base of the support arm.
When the latch is depressed the arm will swing up and out of the way.
2. While disengaged, swing upper arm upwards to a desired point.
3. To lock TRARM, return the support arm to its original position and flip the
release latch backwards.
EMC Part: 19254300 ● Rev. 03 ● 07/28/06
11