User guide

Chapter 4: Front Panel Display and Controls

Press the ESC button on the front panel at any time to return to Normal

Display.

Test User UST1

This function checks whether user stations (USTs) are functioning

properly.

1. Press the

or button to change user port number. Display will read

"OK", "None", or "Failed."

 If a "Failed" condition is detected, make sure the Cat5 UTP cable

is installed properly and secured, or try using another user station

(UST) to see if the user station under test has become defective.

2. Press the ESC button on the front panel at any time to return to

Normal Display.

Test Chan. UKVM

This function checks whether a CIM is functioning properly.

1. Press the

or button to change channel number. Display will read

"OK", "None", or "Failed."

 If a "Failed" condition is detected, make sure the Cat5 UTP cable

is installed properly and secured, or try using another CIM to see if

the CIM under test has become defective.

2. Press the ESC button on the front panel at any time to return to

Normal Display.

Stacking Support

1. Press the

or button to set the Stacking Unit ID number (0~3 for a

P2-UMT832M or 0~1 for a P2-UMT1664M).

 The default is set to "0" (no Stacking Units connected).

 If you wish to add Stacking Units, this number must be equal to the

number of Stacking Units connected.