User guide

Chapter 3: Rackmount and Installation
35
Channel Configuration
Paragon recognizes a HubPac as an extension of a CIM, rather than as a
device. As a result, each server connected to the HubPac is configured as
a directly connected server would be.
1. On the Selection Menu (by channel number) each green line indicates
an active channel (CIM/server). Highlight the CIM/server to be
selected by using the
, , or Page Up, Page Down keys. Press
Enter.
2. Normal server access indicates successful connection. If necessary,
manually adjust the video skew by pressing the + or - keys on the
numeric keypad.
3. Enter a meaningful name for each server (channel).
a. Press F5 for Administration Menu.
b. Select Channel Configuration with
or keys and press Enter.
c. Press
or to highlight (in yellow) the Name field for channel ID
where CIM/server was just installed. Press Enter. The highlight
turns light blue.
d. Edit the name (turns green when typing begins). Press Enter
when completed.
e. Press S to save the new name.
f. Press F2 to return to Selection Menu (by channel number). Verify
that new name appears on the Selection Menu in green.
4. Repeat for each CIM/server desired.