User guide

Chapter 12: Firmware Upgrade
183
STEP (D): Launch the Paragon Update Utility
After the hardware connection is completed, you can execute the Paragon
Update utility to upgrade the firmware. Note that Paragon Update version
2.4.4 or later supports this firmware upgrade. Earlier versions do not have
this capability. Please use the latest version of the Paragon Upgrade utility
which you downloaded along with the HubPac firmware to ensure the
success of the upgrade.
Prior to the firmware update with Paragon Update, ensure the P2-HubPac
is turned on.
To launch the Paragon Update utility
1. Double click “ParagonUpdate_xxx.exe” (xxx represents the version).
The Paragon Update window appears.
2. Specify the device information of the connected HubPac.
a. Type a name for the HubPac in the Name field.
b. Select <Default Serial> in the IP address/Serial field.
c. Type the COM port number that your PC assigns to the HubPac in
the Port field.
3. Select the checkbox (
) beside the HubPac device.
4. Click Load Hex File and navigate to select the appropriate firmware
file.
5. Click Send To Paragon.
6. Click Yes. The utility starts to upgrade the “connected cluster” of the
HubPac.
7. When the connected cluster is upgraded successfully, the “Device
Update Successful” message appears.
Keep the Paragon Update window open if other clusters of the same
HubPac are not upgraded yet. See the subsequent section for more
information.
For more details of the Paragon Update utility, see Paragon Manager
User Guide.