User guide

Chapter 6: Operation - User Functions

The failure of data output can be caused by one of the following reasons:

• Blockage to the FOLLOWER channel port(s). For example, other

user(s) may be accessing one or more of the FOLLOWER channels in

Private mode and thus block the access.

• Mouse/keyboard activity is detected on the FOLLOWER user

station(s) when the Multiple Video command is issued. Paragon will

NOT execute Multiple Video in order to protect that server's operation.

• The FOLLOWER user station is P2-USTIP which enters the remote

mode (no OSUI displayed). This message will be displayed on the

screen.

• The FOLLOWER user station is set to Local PC mode.

• The FOLLOWER user station is P2-EUST/C which detects the

insertion of the smart card. This message will be displayed on the

screen.

• There are not enough FOLLOWER user stations subsequent to the

ACTIVATOR user station. This message will be displayed on the

screen.

Messages on the FOLLOWER User Stations

When the Multiple Video command is issued, a message similar to the

following will be displayed on the FOLLOWER user stations. Any

keyboard and mouse outputs on these user stations are invalid while in the

Multiple Video mode.

Using P2-USTIP for Multiple Video Outputs

P2-USTIP has two operation modes: remote and local modes. Only local

mode supports the Multiple Video function.

In the remote mode (no OSUI displayed):

P2-USTIP CANNOT function as either the ACTIVATOR or FOLLOWER

user station in this mode. If a remote user accesses an ACTIVATOR

channel via P2-USTIP, the Multiple Video function is NOT triggered at all.

In the local mode (OSUI displayed):

This is the only mode in which Multiple Video functions. Enter the local

mode by pressing Ctrl+Alt+Delete. Then P2-USTIP can act as either the

ACTIVATOR or FOLLOWER user station.