User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
CHAPTER 6: MANAGING IBM BLADECENTER SERVERS 85
7. Press F2 to verify the new name in the Selection Menu.
Renaming a Blade Server
By default, each of IBM BladeCenter server is named as “IBM-Blade01,” “IBM-Blade02,” and
so on.
1. When Paragon’s OSUI is on the screen, press F5 to go to the Administration Menu.
2. Select the Channel Configuration submenu, and press Enter.
3. Select the IBM BladeCenter’s channel.
4. Press G to bring up a Channel Configuration menu for the IBM BladeCenter servers.
5. Use the Ç and È keys to highlight the Name field of any server whose name you want to edit.
Figure 78 Renaming the IBM Blade Server’s Channel
6. Press Enter - the highlight will turn light blue.
7. Type the desired server name - the highlight will turn green as you begin to type.
8. Press Enter - the highlight will turn yellow.
9. Repeat steps 5 through 8 if you want to edit other servers’ names.
10. Press S to save the new name(s).
11. Press F2 to go to the Selection Menu and check whether the server names are changed.