User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
CHAPTER 5: PARAGON II AND P2ZCIMS/Z-CIMS 81
3. Press F4 to activate the User Profile Menu.
Figure 74 User Profile Menu
4. Use Tab or the Ç and È keys to move the highlight to the Local PC field.
5. Press Enter. The Local PC field will turn green.
6. Use the Ç or È to toggle the value of the field to “On.”
7. Press Enter. The highlight will turn yellow.
8. Press S to save the change. If you do not wish to save changes, press the Esc key to abort the
change.
Once Local PC Mode is turned on, you can access the dedicated local PC server from this User
Station by pressing the Home key twice rapidly while viewing the OSUI. The User Station will
immediately switch you to the local PC. To return to the Paragon system and its switched servers,
activate the OSUI by pressing the hot key twice (default: Scroll Lock), and access any of the
listed servers from the Selection Menu.