User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
76 PARAGON II USER GUIDE
7. Press Enter and type SetPZSize-NN (NN represents the two-digit number for the size of
your chain, from 01-42).
Figure 71 Resizing the P2ZCIM Chain
8. Press Enter.
9. Press S to save the new chain size.
10. Press F2 to go to the Selection Menu and verify that the chain size has changed.
Refresh a P2ZCIM Chain
The Refresh command resets the Communication Addresses of each P2ZCIM by reassigning all
Communication Addresses sequentially. All active P2ZCIM channels will be rearranged so they
are placed together in the former part of the channel list.
1. At a User Station Login Menu, type admin in the User Name field and press ENTER.
2. Type raritan or your new password in the Password field and press ENTER.
3. If the Selection Menu is not in the channel number view, press F12 to toggle the view.
4. Press the F5 key.
5. Select the Channel Configuration submenu and press Enter.
6. Use the Ç and È or the Page Up and Page Down keys to select the P2ZCIM chain you
wish to refresh.
7. Press Enter and type RefreshPZ.
Figure 72 Refreshing the P2ZCIM Chain
8. Press Enter again.