User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
CHAPTER 4: OPERATION – ADMINISTRATOR FUNCTIONS 65
System Reboot and System Reset
System Reboot and System Reset commands affect your entire Paragon configuration, that is, if
you perform a System Reset on your Base Unit, the 3rd-tier matrix switch(es) will reset, then the
2nd-tier matrix switch(es) will reset, and finally the Base Unit will reset. Each matrix switch
sends a Ready-to-Reset report to Paragon clients (P2SC, Paragon Manager, UST-IP, etc.) as an
event log.
System Reboot
To reboot your Paragon II from the OSUI, select option 5, System Reboot, from the
Administration Menu, and press Enter.
Figure 66 System Reboot
A message in the message bar asks you to confirm the System Reboot command. You must type
Y-E-S, the complete word ‘Yes,’ and press Enter to confirm, or press Esc to cancel. A “Reset”
message screen appears and remains on-screen while your system reboots. If you have multiple
tiers, the reboot will take slightly longer than if you are rebooting only a single Paragon unit.