User guide

CHAPTER 2: INSTALLATION 21
C. Press F5 to activate the Administration Menu. Use the Ç and È keys to move the
highlight to the Channel Configuration entry and press Enter to select it.
Figure 27 Administration Menu
D. The Channel Configuration menu appears. Use the Ç and È keys and Page Up and Page
Down keys to approach channel ports to which subsidiary matrix switches are connected.
The port default device names appear in the Name column and the device type in the
Device column. (“P242” for a 2 x 42 matrix switch [P2-UMT242], “P442” for a 4 x 42
matrix switch [P2-UMT442], “P832” for an 8 x 32 matrix switch [P2-UMT832M], or
“P1664” for a 16 x 64 matrix switch [P2-UMT1664M].
Figure 28 Channel Configuration Menu for a P2-UMT442
E. Continue using the Ç and È keys and Page Up and Page Down keys to move the yellow
highlight to the Name field for the channel port number where a subsidiary matrix switch
is installed and press Enter. The highlight should turn light blue.
F. Type in the name you want to assign to the subsidiary matrix switch on this channel port
(the highlight should turn green when you start typing). Press Enter when finished, and
then press S to save the new name. All other paths (channel ports) by which that
subsidiary matrix switch is attached to the matrix switch above it will be given the same
name automatically.
G. Press F2 to reopen the Selection Menu; make sure that the channel port(s) of the second-
tier matrix switch are properly established. All paths to that matrix switch should be
displayed in purple.