User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
18 PARAGON II USER GUIDE
Note: If your video image is fuzzy (especially if you are using an LCD flat-panel monitor),
you can adjust the video gain to focus the video image. If the OSUI is not displayed, activate
it by pressing the Scroll Lock key twice QUICKLY, then use the + and – (plus and minus)
keys on the numeric keypad to adjust the video image until it appears to be in focus. The P2-
EUST provides automatic and manual skew compensation, which will also help improve
video quality. Please see Video Gain Adjustment and Skew Compensation in P2-EUST in
Chapter 3 for additional information.
B. Press F5 to activate the Administration Menu. Use the Ç and È keys to move the
highlight to the Channel Configuration entry and press Enter.
Figure 23 Administration Menu
7. The Channel Configuration menu appears. Use the Ç and È keys or TAB to move the
yellow highlight to the Name field for the channel port number where you installed the server
and press Enter. The highlight turns light blue.
Figure 24 Channel Configuration Menu of a P2-UMT442
A. Edit the name (the highlight turns green when you start typing). Press Enter when
finished, and press S to save the new name.
B. Press F2 to return to the Selection Menu. Verify that the new name appears in the
Selection Menu.
8. Repeat steps 5 and 6 for each CIM and server you want to connect to the matrix switch’s
channel ports.