User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
APPENDIX F: EXTRA KEYBOARD/MOUSE INFORMATION AND SETTINGS 129
5. Either press Esc to exit the setting mode or close the text editor.
Generic Keyboard Layout Code
LANGUAGE LAYOUT CODE LANGUAGE LAYOUT CODE
Arabic
01
Netherlands
18
Belgian
02
Norwegian
19
Canadian-Bilingual
03
Persian
20
Canadian-French
04
Poland
21
Czech Republic
05
Portuguese
22
Danish
06
Russia
23
Finnish
07
Slovakia
24
French
08
Spanish
25
German
09
Swedish
26
Greek
10
Swiss/French
27
Hebrew
11
Swiss/German
28
Hungary
12
Switzerland
29
International (ISO)
13
Taiwan
30
Italian
14
Turkish
31
Japan
15
UK
32
Korean
16
USA (Default)
33
Latin American
17
Yugoslavia
34
Sun Keyboard Layout Settings (P2CIM-SUN or P2CIM-ASUN)
When you connect a Sun keyboard to the User Station to access a Sun server which is attached
with P2CIM-SUN or P2CIM-ASUN, you must change the Sun keyboard’s layout setting.
1. Select the channel of the desired Sun server in the Selection Menu, and press Enter.
2. Activate a text editor on the server.
3. Press Left Ctrl + Delete to enter the setting mode. A message similar to the following
appears in the text editor.
Current keyboard layout is
set to US5 Unix (code 22).
Figure 111 Sun Keyboard Layout Setting – Initial Message
4. Press the appropriate keyboard layout code (refer to the following table for codes).
5. When you see a “setup end” message similar to the following, the setting is changed
successfully.
Figure 112 Sun Keyboard Layout Setting – End Message
“Setup end” indicates
the setting is changed.