User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
APPENDIX E: CONNECTING SERIAL DEVICES TO PARAGON II SYSTEM 119
Figure 104 AUATC Screen Layout (On Line Mode)
• In line 1 of the top pane, AUATC’s firmware version is displayed at the right.
• In line 3 of the top pane, the cursor position and buffer-page number are displayed at the left
and the terminal type and data rate are displayed at the right.
• In line 4 of the top pane, the communication status is displayed. This status can be:
− On Line: AUATC is communicating with the server and displaying the interactions in its
terminal-screen area.
− Help: If you press ALT + F1, the Help screen appears.
− Set Up: If you press ALT + F2 or ALT + F3, AUATC enters the Setup Mode.
− Buffer Edit: If you press ALT + F4, AUATC enters the Buffer Edit Mode.