User guide

116 PARAGON II USER GUIDE
Rear Mount
1. Secure the cable-support bar to the front end of the side brackets, near the side brackets’
“ears,” using two of the included screws.
2. Slide the User Station or matrix switch between the side brackets, with its rear panel facing
the cable-support bar, until its front panel is flush with the back edges of the side brackets.
3. Secure the User Station or matrix switch to the side brackets using the remaining included
screws (three on each side).
4. Mount the entire assembly in your rack and secure the side brackets’ ears to the rack’s front
rails with your own screws, bolts, cage nuts, etc.
5. When you attach cables to the connectors on the rear panel of the User Station or matrix
switch, drape them over the cable-support bar.
1.
1.
2.
3.
3.
4.
4.
5.
P
2
-
U
M
T
3
2
8
Figure 102 Rear Rackmount of a P2 Matrix Switch
1.
1.
2.
3.
3.
4.
4.
5.
P
2
-
U
S
T
Figure 103 Rear Rackmount of a P2 Matrix Switch