User guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Operation – User Functions
- Chapter 4: Operation – Administrator Functions
- The Administration Menu
- Guidelines for System Configuration
- System Configuration
- Video Redirection (Forced Video)
- Channel Association for Multiple Video
- User Configuration
- Channel Configuration
- User Station Profile
- Group Settings (Access Rights)
- Recommendations
- System Reboot and System Reset
- Network Settings
- Autoscan and Autoskip
- Power Management
- Paragon II Network Port
- Chapter 5: Paragon II and P2ZCIMs/Z-CIMs
- Chapter 6: Managing IBM BladeCenter Servers
- Chapter 7: Configurations
- Chapter 8: Firmware Upgrade
- Appendix A: Specifications
- Appendix B: User Station Direct Mode
- Appendix C: Tiering and Compatibility
- Appendix D: Paragon II Rack Mount
- Appendix E: Connecting Serial Devices to Paragon II System
- Appendix F: Extra Keyboard/Mouse Information and Settings
- Appendix G: Recommendation for Better Video Quality
- Appendix H: Other Components Working with Paragon II
- Appendix I: Troubleshooting
APPENDIX C: TIERING AND COMPATIBILITY 113
Note: Only one Stacking Unit can be connected per Paragon I HW3 switch.
Double Diamond Configuration:
Officially, the Double Diamond configuration is NOT a Raritan-approved solution if stacking
units or P2-HubPac is included in the configuration. Therefore, it is highly recommended to avoid
this configuration especially when using Paragon II stacking units or the P2-HubPac.
UMT
-
3
A
UMT
-
3B
UMT
-
2B
UMT
-
2A
UMT
-
Base
1
Figure 99 Double Diamond Configuration