User guide

Table Of Contents

96 PARAGON II USER GUIDE

Diamond Configurations

Single diamond configuratioin:

A user configured on the second tier and connected to UMT-2A has access only to UMT-3A,

while a user connected to UMT-2B can access both UMT-3A and UMT-3B. The base

administrator has access to all UMTs in the single diamond configuration.

The following procedure must be followed to ensure this configuration functions properly:

− After re-connection, all UMTs should undergo a FUNC reset to clear the database. See

Reset Unit under Paragon II Front Panel Display and Controls in Chapter 2 for more

information on clearing the database. This procedure should be performed starting from

the third-tier device down to the Base Unit.

− Execute the FUNC reset in the following order: UMT-3A → UMT-2A → UMT-2B →

UMT-Base 1.

Figure 90 Single Diamond Configuration

Double diamond configuration:

Officially, the Double Diamond configuration is NOT a Raritan-approved solution if stacking

units or P2-HubPac is included in the configuration. Therefore, it is highly recommended to avoid

this configuration especially when using Paragon II stacking units or the P2-HubPac.

Figure 91 Double Diamond Configuration

UMT

Base

UMT