User`s manual

• To change Name (default is the unit's model number): Move to Name and type a

name up to five characters. This field is usedfor your identification purposes only.

• The Device field specifies the type of device computer or MasterConsole

connected to each channel of the base MasterConsole II unit. <Tab> to the

Device field. You must specify the device for each channel .See Figure 15.

• The Device field consists of a sequence of characters equal to the channel

capacity of the base unit. The leftmost character corresponds to the unit's

channel 1, while the rightmost character corresponds to the highest channel

number.

Figure 15. Device Types

Figure 16. Device Field

For example, in Figure 16, the y . . . . c . . Device field indicates the following: an 8-

channel MasterConsole II MCC8 model is connected to the first channel on the base

MasterConsole II, an 8-channel MasterConsole P Model is connected to the sixth

channel, and computers are connected (or to be connected) to all other channels.

See One-Tier Configuration for instructions on setting/changing other operational

parameters (AutoScan, AutoSkip, ID Display, hot-key, Menu Display, PowerSave).

.(dot) = computer (default)

For non-computers, define the Device as follows:

a = MCP2

b = MCP4

c = MCP8

d = MCP16

x = MCC4, MCS4, MCX4

y = MCC8, MCS8, MCX8

z = MCC16, MCX16

Note: If you specify a MasterConsole P Model, a pop-up box will prompt for banking

information.