User`s manual

Figure 8. Configuration Menu

Assigning Names and Scan Rates (One-Tier)

You may assign meaningful names to quickly and easily identify and select connected

computers. By default, the channel name is PC00aa (where aa is the channel ID number)

and the Channel-Specific Scan Rate is 3 seconds.

1. Activate On-Screen User Interface.

2. Press <F3> to access the Edit Names and Scan Rate Menu. See Figure 9.

3. Use the <Tab>, <Shift-Tab> or <Ï>/<Ð> keys to move the cursor to the line you

want to edit. Use <Í>/<Î> to move within a line.

• To change the Name: Type up to 8 characters (no spaces).

• To change the Channel-Specific Scan Rate (default is 3 seconds): Type a

number from 00 to 99 (seconds). When the AutoScan Mode in the Configuration

Menu is set to Individual, these Channel-Specific Scan Rates are enabled. If the

AutoScan mode is set to Global, the global value will be used.

4. When you move to a different page or exit this Menu, you are prompted to save your

changes. Press <Y> to save.

5. To exit the Edit Names and Scan Rate Menu: Press any Menu F key to go to

another menu, or press <Esc> to go to the Selection Menu.

Note: If your MasterConsole II is a 16-channel model, MCC16, use the <Page

Up>/<Page Down> keys to view the next or previous group of eight channels.