User guide

Chapter 6: Firmware Upgrade
46
STEP 3: Launch the Upgrade Utility
The upgrade utility for MCCAT is the same one for Raritan's Paragon
products, that is, the ParagonUpdate utility. However, the ParagonUpdate
utility which is implemented with the capability to upgrade the MCCAT
switches starts from version 2.4.3. To ensure the success of the upgrade,
it is strongly recommended to use the upgrade utility downloaded along
with the MCCAT firmware when upgrading MCCAT switches.
1. Double-click the downloaded upgrade
utility—ParagonUpdate_XXX.exe, where XXX represents the version
number. The firmware upgrade utility appears.
2. If the MCCAT switch intended to upgrade is already listed in the dialog,
go to Step 3. If not, do the following to specify the device that you want
to upgrade:
a. Click New to start adding the device information.
b. Click the Name field and type the appropriate name for the
MCCAT switch you want to upgrade.
c. Ensure <Default Serial> is selected in the IP address/Serial field
for the serial connection between the MCCAT switch and the
computer you are operating.