User guide

Chapter 4: Advanced Operation and System Configuration
31
2. Press or to change the value or switch between options of the
selected field.
Exception: You need to type a letter or symbol in the Device field to
change its values, instead of using the arrow keys.
The table below explains the functions and available options of each field
in the menu.
Field Available options Description
Connected
No options The field CANNOT be configured. It shows the
number and name of the channel being accessed
now.
Model
No options The field CANNOT be configured. It shows the
model name of the MCCAT switch.
Name
No options You can assign a name to the current MCCAT
switch for identification. The default is its model
name.
Device
x, y, z, . (dot) Specifies the type of the device connected to
each channel of current MCCAT switch. If you
connect a second-tier KVM switch, it is a must to
specify the type of this switch. The characters of
this field represent channel numbers 1, 2, 3, and
so on from left to right. The default value is "."
(dot).
The following lists the characters representing
different types of devices:
. (dot) = computer
x = MCC4
y = MCCAT18, MCC8
z = MCCAT116, MCC16
Scan
On, Off Toggles the AutoScan mode on or off.
If it is ON, after you quit the OSD, the system
enters the scan mode (Global or Individual scan
mode) and cycles through all channels.
Set
05 ~ 99 (seconds) Determines the length of time for which the
system scans each channel in the “Global”scan
mode.
Mode
Global, Individual Determines which scan mode is applied once the
AutoScan function is turned on. There are two
scan modes: Global and Individual.
 Global scan mode: The scan time for each
channel is the same.