User guide

Chapter 2: Quick Start

2. Move the cable-support bar upward or downward to make the

concave slot hold the top edge of the upper L-shaped hole or the

bottom edge of the lower L-shaped hole.

3. Slide the bar horizontally along the edge of the L-shaped hole until the

hole on the end of the bar is aligned with the threaded hole above or

below the L-shaped hole.

4. Secure the cable-support bar with one of the included cap screws.

5. Repeat Steps 1 to 4 to secure the other end of the cable-support bar to

the other rackmount bracket.

After securing the cable-support bar, you can attach the bracket assembly

to the MCCAT switch and mount the device in your rack. See Forward

Mount (on page 9) or Re

ar Mount (on page 9).

Before attaching the bracket assembly to the MCCAT switch

If you attach the cable-support bar to the upper L-shaped holes, turn the

bracket assembly upside down.