Specifications

APPENDIX B: MX4 FRONT PANEL CONTROLS 29
Select Sync Type
This function is disabled on models with Automatic Sync Setting feature. (See System Configuration page 12)
The Select Sync Type function enables the MX
4
to accommodate as many types of VGA monitors as possible, as
some monitors may function erratically without continuous synchronization (Figure 34). The MX
4
can generate
either continuous sync signal or regular sync signal. If a user console monitor exhibits abnormal behavior, try
changing this setting for the user port to which it is connected. Perform steps 1-3 of Function Selection first. To
control the sync type generated for a user port:
1. Press Ç or È buttons to select the user port number.
2. Press the Å button to toggle the sync type between regular and continuous.
3. Press ENT to confirm the selected setting, or
4. Press ESC to return to the Normal Display and retain the previous setting.
Select Sync Type
User 1: Regular
Figure 34 Select Sync Type
Certain versions of MX4 hardware have the auto sync detection function built-in, which will
disable this front panel function.
Reset MX
4
The Reset MX
4
function lets you restart the MX
4
unit as if you had physically turned the unit’s power off and back
on again. However, the MX
4
will not perform the start-up test unless you hold down the ENT button during restart.
Perform steps 1-3 of Function Selection first.
Display Serial Number (DSP Serial Numbr)
The Display Serial Number function lets you review the serial number of your MX
4
unit. See Figure 35. Perform
steps 1-3 of Function Selection first.
SN: CW970000
Esc to Exit
Figure 35 Display Serial Number
1. Press the Ç or È buttons until “DSP Serial Numbr” appears.
2. Press the ENT button to display the serial number of the unit.
3. Press ESC to return to the Normal Display and retain the previous setting.