Specifications

4
TROUBLESHOOTING
A1. Lodged debris.
A2. Flapper not seating
properly.
A3. Joker Valve not closing.
A4.Holding Tank is pressurized.
A5. Scored pump housing or
worn piston "O" ring.
B1. Clogged vented loop.
B2. Improperly installed vented
loop.
C1. Intake line clogged.
D1. Seal leaking.
E1. Organic material lodged in
bowl rim.
E2. Foul intake water.
E3. Full holding tank.
E4. Worn piston "O" ring.
E5. Discharge line clogged.
E6. Improper or contaminated
discharge hose.
A1. Check discharge lines for obstructions. Clear any lodged
debris. See #2 under "Operation".
A2. If the flapper is worn or swollen, replace it. Be sure improper
cleaners are not being used.
A3. Check Joker Valve for wear and debris. Clean or replace.
A4. Clogged holding tank vent or vented loop; clean vent(s).
A5. If pump housing is scored both housing and "O" ring must be
replaced. If "O" ring is worn, replace it.
B1. Clean vented loop.
B2. Refer to Fig. #2 in installation.
C1. Clear intake line, check for build up in hose. Clean strainer.
D1. Replace piston U-Cup seal (#1357) or Seal Cartridge Assy.
(#1356W). Refer to literature (#L190) for seal replacement
instructions.
E1. Connect a garden hose to the spud at the back of the bowl and
flush it out under pressure. Install In-Line Strainer (#163000).
E2. Add a Raritan (#TWK) to deodorize intake water.
E3. Empty Holding tank, be sure vents are clean and functional.
E4. If the Piston "O" ring is worn, replace it.
E5. Clear any debris lodged in discharge.
E6. If hose has foul odor, replace with proper sanitation hose
(#SH).
A. Water accumulates in
the bowl faster than it
pumps out.
B. Water rises in the bowl
when the boat is at
dockside.
C. Intake water flow is
poor.
D. Leak around piston
shaft.
E. A persistent odor comes
from the toilet bowl.
PROBLEM POSSIBLE CAUSE CORRECTION
Part No. Part Name
CH42 Hose (3/4" I.D.)
CH43P Hose Clamp, Nylon (2)
F020 #10 Self-Tapping Screw (6)
F081 Hex head Cap S/S Screw (1/4-20 x 2") (4)
MAJOR SUBASSEMBLIES
CPIILBA Compact II Pump and Base Assy, Complete
CPIIPUMP Compact II Pump Assy. Complete
BOWL AND SEAT
1234 Bowl Gasket
1236AW Spud Assembly (supplied w/bowls)
(not shown)
1236E Bowl Elbow
1237W Marine-size Bowl Assembly (w/1236AW
spud assy.)
1238A Marine-size Seat and Cover
163000 In-Line Strainer
1PCP22 C.P., Cleans Potties, Bio-enzymatic, 22 oz.
RNI Shoulder Washer (4)
TWK Raritan Toilet Water Kit. Allows Raritan
"Concentrate" to be metered into the flush water.
CON22 Raritan "Concentrate" head deodorant and lubricant.
Used with TWK. Replacement bottle 22oz.
CPRKII Compact II Repair Kit
SH 1 1/2" I.D. Sanitation Hose (sold by the foot)
SL Super-Lube 1/2 oz. tube
Part No. Part Name
1115 3/8 - 16 x 1 1/2 Hex HD S/S
1214B "O" Ring
1222AW 90
o
Discharge Ell w/flange
1222B Discharge Fitting - Straight (Optional,
not shown)
1223B 3/8 - 16 S/S Nut (2)
1226A 1/4 - 20 x 1 1/4", RH S/S Screw(4)
1226B 1/4 - 20 Nut, S/S (8)
1226C Plastic Spacer Washer (4)
1228CW Flapper Valve Assembly
1301PW Toilet Base Assembly (w/drain plug)
1316MS Piston "O" Ring
1343 Plastic Drain Plug, 1½" NPT
1346 Check Valve Housing
1347 Separator Plate
1348 Cam
1349W Shutoff Handle w/seal
1350W Check Valve Assy. (1350,1351 & 1352)
1353 Bumper Washer (2)
1354 Flushing Handle
1355 Pump Housing, Compact II
1356W Seal Cartridge Assy. (1214B & 1357)
1357 U-Cup Seal (2)
1359W Piston Rod Assy.(1316MS, 1353 & 1359A)
C253 Joker Valve
PARTS FOR COMPACT II MARINE TOILETS