User guide

Chapter 8: Port Configuration and Port Access Application

Change as follows:

 Select control from the drop-down menu in the Escape Mode

field.

 Type the character in the Escape Character field. The default for

the Dominion SX is ] (closed bracket).

Note: See Configuring Ports (on page 153) for details on port

configuration commands.

7. Select the terminal emulation type from the drop-down menu in the

Emulation field. The choices are:

 VT100

 VT220

 VT320

 ANSI

8. Set Encoding if you want the RSC for this port to always use a

specific character encoding. It will override the global RSC setting for

this port to whatever value you set. The choices are:

DEFAULT,US-ASCII,ISO8859-1, ISO8859-15,UTF-8, Shift-JIS,

EUC-JP, EUC-CN, EUC-KR.

9. If you need to configure the length of the send break signal for

targets that require a short or longer sendbreak duration, enter the

send break time in the Send Break Duration field. The send break is

configurable from 100ms - 1000ms in 100ms increments.

10. If you plan to use Direct Port Access (DPA), you must enter either an

IP address or one/both of the following TCP ports, depending on

your choice of the DPA service mode:

 The port number, such as 7700, in the DPA SSH TCP Port field

 The port number, such as 8800, in the DPA Telnet TCP Port

field.

11. In the Always Active field, indicate if you want to log activities coming

into a port even if no user is connected. The default option is Do not

maintain port access without a connected user, which means: ignore

data coming into a port when no user is connected. Change by

selecting Maintain port access continuously from the drop-down

menu in the Always Active field. This option is for NFS port data logs.

Note: When no users are logged into a port session, port traffic, by

default, will be discarded .

12. Select none or all from the drop-down menu of Messages

suppressed field to indicate if any message should be displayed

during a DPA connection, such as "Authentication successful."

Otherwise, it will go directly to the port without displaying any

message. The default is none.