User guide

Chapter 5: Network Settings and Services
27
c. Select Console Only to allow only console connections. Allows
only CLI access through a terminal emulation programs such as
Hypertreminal.
4. If you selected All or PPP Only as the modem access mode:
a. Type the IP addresses of the Point-to-Point (PPP) server in the
PPP Server IP field. The default is 10.0.0.1
b. Type the IP address of the PPP client in the PPP Client IP field.
The default is 10.0.0.2.
5. If you selected PPP Only as the modem access mode:
a. If you want to enable modem dialback, select the Enable Modem
Dial Back check box.
6. Click OK. Modem access is enabled. You will then receive a
message indicating that the device will need to be rebooted for the
modem changes to take effect.
Configuring IP Forwarding and Static Routes
You can enable IP forwarding. You can also create static routes if your
SX has two LAN ports or is configured for modem access.
Enable IP Forwarding
To enable IP forwarding:
1. Choose Setup > Static Routes. The Static Routes page opens,
containing an Enable IP Forwarding panel and a Static Routes List.
2. Go to the IP Forwarding panel and click the Enable IP Forwarding
checkbox.
3. Click OK. IP forwarding is enabled.