User guide

Chapter 5: Network Settings and Services
23
Configure the Network Settings of Dominion SX
To configure the network settings:
1. Select either None or DHCP from the drop-down menu to determine
a method for IP Auto Configuration. The default is DHCP.
2. Type an IP address for the Dominion SX in the IP Address field.
3. Type the subnet mask in the Subnet Mask field.
4. Type the IP address of the gateway router in the Gateway IP
Address field.
5. Select the speed from the drop-down menu in the Mode field. Your
choices are Auto (default) or 100 Mbps.
6. Type your domain name in the Domain field.
7. Click OK.
Change the Discovery Ports
The Dominion SX has two discovery ports:
 TCP 5000 Common Socket Connection (CSC) discovery
 UDP 5000 Command Center (CC) discovery
If either of these ports is used by another application, you can change
the discovery port number in the Dominion SX in the appropriate field
and click OK.
Note: The port range for internal port configuration (CSC, HTTP, HTTPS,
SSH, Telnet, DPA SSH , DPA Telnet) is 1 ~ 64510, while the
configurable port range for socket creation is limited to 1024 ~ 64510.
External port configuration (LDAP,RADIUS,TACACS+,SNMP) is not
affected by this port range limitation, but allowed with full range of
configuration.
Configuring the Network Service Settings
The table below indicates the default settings for the various network
access services:
Service
Default Setting
HTTP
Enabled. The default port is 80. This can be
changed.
HTTPS redirect is enabled by default. If HTTPS
is also enabled, all HTTP requests are
automatically redirected to the HTTPS port (see
below).