User guide

Chapter 4: Initial Software Configuration

After you click OK, the system displays one of the following pages:

 A confirmation page, which contains the settings you chose and a

confirmation message at the top of the page.

 An error page, which contains the original Date / Time page and the

error message.

Network Configuration

1. Choose Setup > Network. The Network Configuration page opens.

Note: If you have a dual LAN model, there is an Enable Ethernet

Failover checkbox that is selected by default, but can be deselected.

The page below represents a single LAN model and does not show

this checkbox.

Note: Your network administrator usually assigns the values for the

following parameters:

2. Type the data in the following fields:

 IP Auto Configuration: In the drop-down menu, select either None

or DHCP to be your network protocol. The default is DHCP. If

DHCP is unavailable, the device will use the last IP entered,

such as the default factory setting of 192.168.0.192.

 IP Address: Network address for this unit.

 Subnet Mask: Subnet mask for the network where this unit will

reside.

 Gateway IP Gateway: Default gateway for this unit.