User guide

Chapter 3: Installation
14
Network Configuration
1. Type Configuration to change the unit's configuration.
2. Type Network to select the network configuration.
3. Type:
admin > Config > Network > interface enable true if
lan1 ip 192.16.151.12 mask 255.255.255 gw 192.168.51.12
Upon successfully entering the data, a report will display the new
network configuration and you will be prompted to reboot the unit.
4. Type yes to reboot the Dominion SX.
5. Remove the serial cable.
6. Reconnect from the installation computer browser to the Dominion
SX using the new IP address and password.
User Configuration
1. Type Configuration to change the unit's configuration.
2. Type Users to select the user configuration.
To Add a User Group
Type addgroup name <group name> class <class type> ports
<n1,n2,n3...> where <group name> is the name of the group and
<class type> is
 Op for operator
 Ob for observer
<n1,n2,n3...> is a list of port numbers to which this group has access,
separated by commas but no spaces. You can configure port ranges
using the same parameters, or use the wildcard asterisk (*). For
example:
 "config port 3-7 exitstring #0" (this disables exit strings for ports
3,4,5,6,7)
 config port * bps 115200 (this sets all ports to a communications
speed of 115200 bps)
To Add a User
1. Type adduser user <user name> fullname <full name> group
<group name> password <password> info <information>
dialback <dialback number> active <status> where:
 <user name> is user's login name
 <full name> is a user's descriptive name (no spaces)