User guide

Chapter 3: Installation

5. Type a new password, and then retype it (Remember this password).

A page opens, showing the Dominion SX unit's status and serial

channel ports.

Note: If the password entered does not follow the password rules, an

error message will appear as a warning. You will be logged out and

must start over to set your password.

Network Access

1. Ensure that the installation computer has the route for 192.168.0.192

and that it can communicate with IP address 192.168.0.192.

2. To check the route table in Windows

, type the command route print

in a Command window on the installation computer. If 192.168.0.192

is on the gateway list, proceed to step 3. Otherwise, add

192.168.0.192 to the gateway list using the appropriate DOS or

UNIX

CLI command:

 Windows 98/2000/NT system: route add 192.168.0.192

<INSTALLATION COMPUTER IP ADDRESS>.

[Example: route add 192.168.0.192 15.128.122.12]

 UNIX (including Sun Solaris) system:

route add 192.168.0.192 <CLIENT_HOST IP ADDRESS>

-interface.

[Example: route add 192.168.0.192 15.128.122.12

-interface]

3. Type ping 192.168.0.192. Go to step 4 if you receive a

successful reply from the Dominion SX unit. If an error occurs, verify

that the default IP address is entered correctly and that a route to

that IP address exists.

4. Use the installation computer to connect to the unit by launching a

browser and typing the factory default IP address 192.168.0.192 in

the Web browser's address bar.

Set Date and Time

1. Type Configuration to change the unit's configuration.

2. Type Time to select the Date / Time configuration.

3. Type Timezonelist and find the numerical code that corresponds

to your time zone.

4. Type clock [tz timezone] [datetime datetime-string]. For

example:

admin > Config > Time > clock tz 9 datetime "2007-02-05

09:22:33"

In this example, 9 is the time zone code (Step 3) and "2007-02-05

09:22:33" the date/time string in the format "YYYY-MM-DD

HH:MM:SS" (quotes required).