User guide

Chapter 3: Installation
12
The login dialog appears after you finish viewing the security alerts
and the Certification Information screen.
Log in with the default username admin and password raritan. Use all
lowercase letters.
7. After login, the Dominion SX prompts you to change the default
password:
8. Type a new secure password then retype it (Remember the new
password for next login.)
9. Click OK. The Dominion SX Port Access page opens. (See Initial
Software Configuration (on page 16) for details.)
Initial Configuration Using the Command Line Interface
To initially configure the Dominion SX unit from the Command Line
Interface, follow the steps below.
1. Connect the serial port of your Installation Computer to the Terminal
serial port on your Dominion SX. This port is a DB9-Male port on
most models, except ALL dual-power dual-LAN models, including
DSXA-48, which have an RJ45 connector for a terminal port.
2. Open a terminal emulation program, such as HyperTerminal, to
connect to the Dominion SX unit. The serial communication
parameters are 9600 bps, No parity, 8 data bits, 1 stop bit and None
flow control.
3. Power ON the Dominion SX.
4. Log in using the default username admin and the default password
raritan when prompted.
Once logged in, a prompt to change the password appears.