User guide

Chapter 3: Installation

5. Connect the female end of the external power cord to the back of the

chassis.

6. Connect the male end of the external power cord to the power supply

outlet.

7. Power ON the Dominion SX unit.

Note: The unit will perform a hardware and firmware self-test, then start

the software boot sequence, which takes a short time. It is complete

when the light turns on and remains on.

After completion of the hardware and firmware self-test and the software

boot sequence, perform the initial configuration tasks using the Graphical

User Interface (GUI) or the Command Line Interface (CLI) as described

in the following sections.

LED State

On the front panel of the Dominion SX unit, there are LED indicators on

each side of the device. The green LED will be lit at the same time the

blue LED is lit. The blue LED indicator will blink blue in the following

three cases:

1. Ethernet packets are received or transmitted.

2. Serial data are received or transmitted.

3. Watchdog timer is reset to 0. The LED blinks on a periodic basis as

the watchdog timer reaches a certain value, and then is reset to 0.

Initial Configuration Using the Graphical User Interface (GUI)

To initially configure the Dominion SX unit from the GUI , follow these

steps.

Network Access

1. Ensure that the installation computer has the route for 192.168.0.192

and that it can communicate with IP address 192.168.0.192.

2. To check the route table in Windows

, type the command route print

in a Command window on the installation computer. If 192.168.0.192

is on the gateway list, proceed to step 3. Otherwise, add

192.168.0.192 to the gateway list using the appropriate DOS or

UNIX

CLI command:

 Windows 98/2000/NT system: route add 192.168.0.192

<INSTALLATION COMPUTER IP ADDRESS>.

[Example: route add 192.168.0.192 15.128.122.12