User guide

7
There are two ways of completing the initial network installation of the
Dominion SX:
 Using a serial cable with a VT100/equivalent, such as a PC with
HyperTerminal
 Using Ethernet (with an installation computer)
This section describes the steps necessary to configure Dominion SX for
use on a local area network (LAN). The following table describes the
factory default network settings that come with the Dominion SX. After
units are connected to the network, these factory default settings allow
you to configure the Dominion SX for normal use.
Default Network Settings
Internet Address (IP)
192.168.0.192
Gateway Address
192.168.0.192
Subnet Mask
255.255.255.0
CSC Port Address
5000
Port Address for CC
Discovery
5000
Username
admin (all
lowercase)
Password
raritan (all
lowercase)
Note: The settings listed in the table above are applicable only if no
DHCP server is running on the network. If a DHCP server is running on a
local network, the Dominion SX unit is assigned a different IP address
than the default by the DHCP server.
In This Chapter
Pre-Installation ........................................................................................... 8
Hardware Installation ................................................................................. 8
Chapter 3
Installation