User guide

Chapter 13: Command Line Interface
182
Reboot Command
The reboot command restarts the Dominion SX console server. This
command is only available to users with administrative privileges. All
user sessions will be terminated without warning, and no confirmation
will be required. It is highly recommended that you ask all users to log off
before you reboot the unit. The userlist command can be used to display
a list of connected users and sessions.
Syntax
reboot
reboot Command Example
admin > Maintenance > reboot
The system responds with the following messages:
Rebooting the system will log off all users.
Do you want to proceed with the reboot? (no/yes) (default:
no) yes
Restore Command
The restore command retrieves a copy of the Dominion SX system from
a system and writes the file to the Dominion SX server.
Syntax
restore [ip ipaddress] [login login] [password password]
[path pathname] [file filename]
restore Command
Description
[ip ipaddress]
IP address of the target system from which
the restore data will be retrieved
<login login>
Username of the account on the system
where the restore data is stored
<password
password>
Password for the above account
[path pathname]
Specifies the path to the backup file to be
restored to a similar system with the same
port density
[file filename]
Specifies the name of the file in which the
backup data was saved