User guide

Chapter 13: Command Line Interface
161
Enable: 1
Group Settings:
Name: Anonymous
Class: Operator
Ports:
To configure Anonymous group settings choose config > user and
execute the following command:
admin > Config > User > editgroup name Anonymous class
op ports 1,2,3,4,5
Editing group...
Group Anonymous: Configuration Saved
The 'Anonymous' group is successfully configured.
DPA Anonymous access
The DPA is already configured (see the DPA configuration settings
section).
DPA Mode is IP, IP 10.0.13.240 is assigned to port 1.
When accessing the serial port with Anonymous port access, user name
should be "anonymous" and empty password <blank> as shown below.
Anonymous access is granted if both username and password fields are
empty (<blank>).
Note: If "anonymous" with a lower case a is entered, the application will
allow access without prompting for a password.
ssh -l anonymous 10.0.13.240
Password:
Authentication successful.
Starting DPA for port 1
Authentication successful.
Escape Sequence is: Control-]
If suppress option is "all", no authentication credentials are shown and
you jump directly to the target prompt.
configuration > ports > config port 1 suppress all
ssh -1 anonymous 10.0.13.240