User guide

Chapter 13: Command Line Interface
160
Note: There is currently no way to set the device back to the default DPA
IP of 0.0.0.0.
dpa Command Example
The following example chooses the DPA IP mode IP:
admin > Config > Services > dpa mode IP
Note: When any changes are made over DPA mode and ports DPA
configuration, the Dominion SX needs to be rebooted to apply new
settings. DPA changes will not be available until after the Dominion SX is
rebooted.
After a successful DPA connection, try the following:
ssh -l sx_user 10.0.13.1
Password:
Authentication successful.
Starting DPA for port 1
Authentication successful.
Escape Sequence is: Control-]
You can now go directly to port 1 using the newly assigned IP.
To disable DPA (set by default, this option could be used after you have
explicitly enabled DPA before):
admin > Config > Services > dpa mode Normal
Enabling unauthorizedportaccess to a set of ports assigned to
'Anonymous' group.
Unauthorized port access is available only for configured DPA methods.
Use the following command:
admin > Security > LoginSettings > unauthorizedportaccess
enable true
When unauthorizedportaccess is enabled, it automatically enables
Anonymous group and the user is able to configure it according to his
requirement:
admin > Security > LoginSettings > unauthorizedportaccess
Unauthorized Port Access Settings: