User guide

Chapter 13: Command Line Interface
147
Commands
Description
routeadd
Add route to kernel routing table
routedelete
Delete route of kernel routing table
Note: All operations that normally trigger a reboot or prompt the user for
feedbacks are now added a new parameter named force. This force
parameter prevents reboot, prompting or both from taking place until all
configurations are completed. The commands that now have a force
parameter are: ethernetfilover (see "Ethernetfailover
Command" on page 147), interface (see "Interface Command" on
page 147), name (see "Name Command" on page 148), ports (see
"Ports Command" on page 149), factoryreset (see
"Factoryreset Command" on page 180) and reboot (see "Reboot
Command" on page 182).
Ethernetfailover Command
The ethernetfailover command is used to enable and disable the ability
to failover from one LAN to another.
Syntax
ethernetfailover [enable <true|false>] [interval value]
[force <true|false>]
Interface Command
The interface command is used to configure the Dominion SX network
interface. When the command is accepted, the unit automatically reboots
and drops the connection. You must then reconnect using the new IP
address and the username admin and password newp/w in the resetting
factory default password section.
Syntax
interface [enable <true|false>] [if <lan1 | lan2>] [dhcp
<true|false>] [ip ipaddress] [mask subnetmask] [gw
ipaddress] [mode <auto | 100fdx>] [force <true|false>]
interface Command
Description
enable <true|false>
Enable/Disable Interface
dhcp
Enable DHCP as ip configuration
if <lan1 | lan2>
Select LAN interface you are configuring
ip ipaddress
IP Address of the Dominion SX assigned for
access from the IP network
mask subnetmask
Subnet Mask obtained from the IP
administrator