User guide

Chapter 13: Command Line Interface
125
RSC Version: 1.0.0.1.16
Supporting software:
OpenSSH_4.3p2, OpenSSL 0.9.7i 14 Oct 2005
HTTP Server version: Apache/2.2.0
HTTP Server built: Mar 29 2006 16:06:30
TELNET Linux NetKit 0.17
Note: Dominion SX security is not impacted if the version of Apache 2.2
installed on the remote host is older than 2.2.9.
Initial Configuration
Dominion SX units come from the factory with default factory settings.
When you first turn on and connect to the unit, you must set the following
basic parameters so the device can be accessed securely from the
network:
1. Reset the administrator password.
All Dominion SX units are shipped with the same default password;
therefore, to avoid security breaches it is imperative that you change
the admin password from “raritan” to one customized for the
administrators who will manage the Dominion SX device.
2. Assign the IP address, subnet mask, and gateway IP address to
allow remote access.
3. Set the time and date.
After the preceding parameters are set, the rest of the system
configuration can be performed.
Setting Parameters
To set parameters, you must be logged on with administrative privileges.
At the top level, you will see the "Username" > prompt, which for the
initial configuration is "admin". Enter the top command to return to the
top menu level.
Note: If you have logged on with a different user name, that user name
will appear instead of admin.