User guide

Chapter 10: Logging

Note: If no specific IPs are entered for the port data destination

servers, port logs are sent to the Syslog server configured in the

System Logging section. If the Syslog category is set to Local0, then

system events and port logs are sent to all servers configured in the

System Logging"section and Port Syslog section.

3. Type the IP address of the remote Syslog server in the Primary IP

Address field.

4. If you have a backup Syslog server, type its IP address in the

Secondary IP Address field.

5. Click OK.

Enable Port Logging

Configure NFS port logging after you have enabled NFS Logging (see

Configuring NFS Logging for details).

This feature enables port data to be logged to a Network File System

(NFS) server, allowing you to save and access the log files over a

network.

NFS supports file sharing, which means you can store the files on the

network that you want other people to access, while keeping your secure

files on the Dominion SX unit. NFS stores the port sessions as viewed

by the user, as well as adding messages when a user connects to or

disconnects from a port.

To set up port logging:

1. Go to the Port Logging panel and select the Enable NFS Port

Logging checkbox. To turn this feature off, deselect this checkbox.

2. Type the prefix to the port data file's name on the NFS server in the

File Prefix field.