Specifications

66 DOMINION SX INSTALLATION AND OPERATIONS MANUAL
Factory Reset
You may want to perform a factory reset, or hard reset, to the Dominion SX unit to revert the configuration
to known defaults. This is useful if the IP address of the unit is no longer known. Using the following
procedure, the network settings of the unit will be reset to the values shown in the table below, and all ports
will be reset to 9600 baud, no parity checking, and no flow control.
Internet Address (IP) 192.168.0.192
Gateway Address 192.168.0.192
Subnet Mask 255.255.255.0
Port Address 51000
Port address for CC Discovery 5000
Username admin
Password raritan
Note: Factory reset does not remove the user-installed certificate from the unit.
There are two methods for performing factory reset; via CLI, or by using a factory reset adaptor or a reset
switch, Both methods are outlined below. When resetting using a factory adaptor or reset switch, it is not
necessary to remove the device from all networks (an Administrator should make this decision).
To factory reset via CLI, use the following commands:
dominion:Diagnostics> factory_reset
Factory Reset Network Settings:
Name: DominionSX
Domain: raritan.com
System Port: 51000
Discover Port: 5000
IP: 192.168.0.192
Net Mask: 255.255.255.0
Gateway: 192.168.0.192
Performing a factory reset will erase ALL system settings.
All system settings will be returned to factory defaults, including network settings (e.g. ip, gateway, et
cetera).
Do you wish to continue? (no/yes) (default: no) yes
Reboot the machine; the following text appears:
Welcome to Raritan Dominion Server
Username: admin
Password: raritan
Authenticating [admin].....Authenticated.
User Type [Administrator]
User Name [Administrator]
System is in reset state.
Please enter new administrator password.
New Password:
Re-Enter New Password: