Specifications

APPENDIX B: SYSTEM DEFAULTS 97
Appendix B: System Defaults
Dominion SX system defaults, as shipped from Raritan, are defined in the table below.
ITEM DEFAULT
IP Address 192.168.0.192
Subnet Mask 255.255.255.0
Port Address 51000
Port address for CC discovery 5000
Factory default username admin
Factory default password raritan
GENERAL SETTINGS
Modem Disabled
RADIUS Disabled
LDAP Disabled
NTP Disabled
Local Port Access Enabled
Syslog Disabled
TACACS+ Disabled
Event Notification Disabled
Dialback Disabled
IP-ACL Disabled
Telnet Disabled
SSH Enabled
SNMP Disabled
Logging to NFS Disabled
SERIAL PORTS
Baud Rate 9600
Parity None
Flow Control None
To initiate access using http, Ports 80, 443 and 51000 (can be configured) must be kept open in the firewall
in order for the unit to be operational. When using https SSL(S) only, TCP port 443 needs to be open; port
80 can be closed. For SSH access, TCP port 22 needs to be open; for Telnet access, port 23 needs to be
open.
Please note that you may need to open additional ports when using syslog, FTP (used in firmware upgrades
from the GUI), NFS logging, LDAP servers, etc. These ports may vary from installation to installation,
depending on network topologies, VLANs, and firewall configurations. Please contact your network
administrator for site-specific information and settings.