User guide

Chapter 8: Port Configuration and Port Access Application

Note:AnonymousaccessshouldbeenabledforDPAtosucceed.

11. ClickOK.

Direct Port Access

Toconfiguredirectportaccess:

1. ChooseSetup>Services.TheNetworkServiceSettingsscreen

appears.TheDirectPortAccessModefieldisatthebottomofthe

screen.



2. GototheDirectPortAccessModefield.ThedefaultisNormal,

whichmeansCLIDPAaccessisdisabled.ToenableDPA,select

eitherIPorTCPPortfromthedrop‐downmenu.

3. ClickOKtosavethisinformation.Thescreendisplaysthefollowing

message:

Thesystemwillneedtoberebootedforchange

stotake

effect.

4. YoumayrebootnowifyouhavealreadysetuptheportsforDPAor

areotherwisepreparedfortheDPAmodetobecomeeffective.

5. ChooseSetup>PortConfiguration.ThePortConfigurationscreen

appears(asshowninPortConfiguration(onpa

ge48

)section).

6. Selecttheportstoconfigurefordirectportaccess:

 Toselectspecificports,clickthecheckboxestotheleftoftheport

number.Youcanselectmorethanone.Whenyouhavefinished,

clickEdit.

 Toselectalltheports,clickSelectAll.

TheEditPortConfig

urationscreena

ppears(asshowninPort

Configuration(onpage48)section).Th

eDPAfieldsareatthebottom

ofthescreen.

7. TypetheDPAIPaddressoftheDSX,andtheDPAportsusedforSSH

andTelnetintheappropriatefields.

8. ClickOKtosavethisinformation.

9. ReboottheDSXunit.Thisisnecessaryforthedirectportaccess

setti

ngstota

keeffect.