User guide

Chapter 4: Initial Software Configuration



Note:Yournetworkadministratorusuallyassignsthevaluesforthe

followingparameters:

2. Typethedatainthefollowingfields:

 IPAutoConfiguration:Inthedrop‐downmenu,selecteither

NoneorDHCPtobeyournetworkprotocol.DefaultisNone.

 IPAddress:Networkaddressforthisunit

 SubnetMask:Subnetmaskforthenetworkwherethisunitwill

reside

 Ga

tewa

yIPGateway:Defaultgatewayforthisunit

3. SelecttheModefromtheModedrop‐downmenu.DefaultisAuto.

4. TypetheDomainNameintheDomainfield.

5. TypeyourUnitNameintheUnitNamefield.

6. InthePortssection:

 Type5000oranotherportnumberintheCSCPo

rtfiel

d.

 Type5000oranotherportnumberintheDiscoveryPortfield.