User guide

Dominion SX Initial Software Configuration
20
 SynchronizewithNTPServer‐Clickthisradiobuttonandenter
theIPaddressofaNetworkTimeProtocol(NTP)serverinthe
PrimaryTimeServer.IfyouhaveabackupNTPserver,enterits
IPaddressintheSecondaryTimeServerfield.
4. ClickOK.
Note:Featuressuchascertificategen
erationdependonthecorrect
Timestamp,usedtocheckthevalidityperiodofthecertificate.In
addition,theSyslogandNFSloggingfeaturesalsousethesystem
timefortime‐stampinglogentries.
AfteryouclickOK,thesystemdisplaysoneofthefollowingscreens:
• Aconfirmationscreen,whichcontainsthesettingsyouchoseanda
confirmationmessageatthetopofthescreen.

• Anerrorscreen,whichcontainstheoriginalDate/Timescreenand
theerrormessage.

Network Configuration
1. ChooseSetup>Network.TheNetworkConfigurationScreen
appears.
Note:IfyouhaveadualLANmodel,thereisacheckboxofEnable
EthernetFailoverthatisselectedbydefault,butcanbeturnedoff.
ThescreenbelowrepresentsasingleLANmodelanddoesnotshow
thischeckbox.