User guide

Hardware Installation

4. ConnecttheotherendofthenetworkLANcabletothenetworkcard

intheinstallationcomputer.

5. Connectthefemaleendoftheexternalpowercordtothebackofthe

chassis.

6. Connectthemaleendoftheexternalpowercordtothepowersupply

outlet.

7. PowerONtheDominionSXunit.

Note:Theuni

twillperformaha

rdwareandfirmwareself‐testthenstart

thesoftwarebootsequence,whichtakesashorttimeandiscomplete

whenthelightturnsonandremainson.

Aftercompletionofthehardwareandfirmwareself‐testandthesoftware

bootsequence,performtheinitialconfigurationtasksusingtheGraphical

UserInterface(GUI)ortheCommandLineInterface(CLI)asdescribedin

thefollowingsections.

LED State

OnthefrontpaneloftheDominionSXunit,thereexistsaLEDindicator

rightnexttothemodelnamelabel.TheLEDindicatorwillblinkbluein

thefollowingthreecases:

1. Ethernetpacketsarereceivedortransmitted.

2. Serialdataarereceivedortransmitted.

3. Whenwatchdogtimerisre

setto0.TheLEDblink

sonaperiodicbasis

asthewatchdogtimerreachesacertainvalue,andthenisresetto0.

Initial Configuration Using the Graphical User Interface

(GUI)

ToinitiallyconfiguretheDominionSXunitfromtheGraphicalUser

Interface,followthestepsbelow.

Network Access

1. Ensurethattheinstallationcomputerhastheroutefor192.168.0.192

andthatitcancommunicatewithIPaddress192.168.0.192.

2. TochecktheroutetableinWindows,typethecommandrouteprint

inaCommandwindowontheinstallationcomputer.If192.168.0.192

isonthegatewaylist,proceedtostep3.Otherwise,add19

2.168

.0.192

tothegatewaylistusingtheappropriateDOSorUNIXCLI

command: